|
|||
.NET, Delphi, ... - Sisulizer Localization Tool Support > Technical Support (You need to be registered at the forum to write) > Usage - Three simple steps to localize > Dynamically switch languages via your VCL?
|
Moderated by: Sisusupport, Renate.Reinartz, Markus.Kreisel, Ilkka.Salmenius |
|
Dynamically switch languages via your VCL? - Usage - Three simple steps to localize - Technical Support (You need to be registered at the forum to write) - .NET, Delphi, ... - Sisulizer Localization Tool Support | |||||||||||||||||
Author | Post | ||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
|||||||||||||||||
chcw Member
![]() |
Hi, Currently I am using Delphi XE3 built-in localization tool. Everything is fine, except this method does not allow me to switch the language dynamically. So I just wonder if your VCL can: 1. Utilize the resource DLL generated by Delphi XE3? 2. Allow switch language easily. 3. Do not need to make big changes to the existing form or replace the VCL controls. Also if the run-time switch of lanague is possible, I just wonder what is the advantage of your solution over the Delphi built-in localization solution, other than the run-time switch feature? Thanks Last edited on Fri Dec 25th, 2020 09:16 pm by chcw |
||||||||||||||||
|
Current time is 01:53 am | |
.NET, Delphi, ... - Sisulizer Localization Tool Support > Technical Support (You need to be registered at the forum to write) > Usage - Three simple steps to localize > Dynamically switch languages via your VCL? |
Sisulizer software localization tool - Three simple steps to localize